One cable slipping off its drum groove is enough to jam a door mid-cycle or send a panel crashing at an angle. We fix the cable and check why it slipped in the first place.
Matching wear on both cables means both get inspected and typically replaced together.
Frayed cables often trace back to worn or damaged drum grooves, so we inspect the drums every time, not just the cable.
Lift cables connect directly to spring-loaded drums, so replacement requires the same careful tension handling as spring work.
Cable stock in standard gauges means most replacements happen in a single visit.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
We replace the snapped cable and its pair, then verify even tension across both sides.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
A door hanging crooked usually means one cable or spring has failed while the other holds. We correct both the immediate hazard and the root cause.
Tell us if the door is hanging crooked or jammed, that detail helps us prioritize the call correctly.
Cable stock on the truck means most calls avoid a second trip for parts.
We check both cables and the drums together, then quote a flat price covering the full fix.
We verify the door hangs and travels evenly before calling the repair complete.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
We recommend replacing both since they wear on the same cycle, and we'll explain the reasoning before you decide.
We treat cable failures as priority calls given the safety risk involved.
We check the drum groove condition whenever a cable keeps coming off, since replacing just the cable won't fix a bad drum.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of St. Bernard to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for St. Bernard, OH